Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Front Door)
RM30B0U _59 Vehicle Exterior _010076 WINDOW / GLASS _0054872 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

Hide 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 4.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

Hide 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

Hide 6.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 7.REMOVE FRONT DOOR ASSIST GRIP COVER LH

Hide 8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 9.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 11.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 12.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.
E268550

Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.

NOTICE:

Be careful when removing the screws as the motor may fall and become damaged.