Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM30B0U _59 Vehicle Exterior _010076 WINDOW / GLASS _0054873 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart.


Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS


PROCEDURE

Hide 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.


b.
E268559

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 4.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 5.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 6.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 8.INSTALL DOOR ASSIST GRIP COVER LH

Hide 9.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 10.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL LH

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION