Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM30B0U _59 Vehicle Exterior _010075 WIPER / WASHER _0054887 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

Hide 3.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 6.REMOVE STEERING WHEEL ASSEMBLY

Hide 7.REMOVE STEERING COLUMN COVER

Hide 8.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E268398
2,0.969 2,0.354 true 1.927,0.188 2.24,0.385 0.313,0.198 10 *1
*1 Protective Tape


Disconnect the 2 connectors.


b.

Using a screwdriver, detach the claw and remove the windshield wiper switch assembly.

NOTICE:

Do not push the claw with excessive force as damage may occur.


HINT:

Tape the screwdriver tip before use.