Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM30B0U _59 Vehicle Exterior _010075 WIPER / WASHER _0054888 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT BUMPER COVER

Hide 2.REMOVE FRONT FENDER LINER RH

a.
E268384

Using a screwdriver, remove the 6 clips.


b.

Partially remove the front fender liner RH.

HINT:

It is not necessary to fully remove the front fender liner RH. Partially remove it so that the front bumper assembly can be removed later.



Hide 3.DRAIN WASHER FLUID

a.
E268371

Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 4.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E268372

Disconnect the connector and hose.


b.

Pull out the windshield washer motor and pump assembly from the packing of the windshield washer jar assembly.


Hide 5.REMOVE WASHER INLET SUB-ASSEMBLY

a.
E268373

Remove the clip.


b.

Pull the washer inlet sub-assembly upward to remove it from the windshield washer jar assembly.


Hide 6.REMOVE WINDSHIELD WASHER JAR ASSEMBLY

a.

Disconnect the 2 connectors and detach the 6 clamps.

E268374


b.

Remove the 3 bolts. Then detach guide A and remove the windshield washer jar and pump assembly.


Hide 7.REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

E268375

a.

Remove the headlight cleaner motor and pump assembly.


Hide 8.REMOVE HEADLIGHT CLEANER CONTROL RELAY

E268376

a.

Detach the claw and remove the headlight cleaner control relay.