Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM30B0U _55 Steering _010121 POWER ASSIST SYSTEMS _0054952 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1541/13  Vehicle Speed Signal  


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the brake actuator assembly via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed based on the signals.

If the ECU detects this DTC, it adjusts the amount of power assistance for a speed of 140 km/h (87 mph) and continues system control.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
C1541/13 Vehicle Speed Signal This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more.
·

Speed sensor circuit

·

Brake actuator assembly

·

CAN communication system

·

Power steering ECU assembly


On Ignition switch ON again

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing (Click here Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0129/42 is output.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

Result:
Proceed to
U0129/42 is not output
U0129/42 is output


HINT:

DTC U0129/42 indicates a brake actuator assembly communication malfunction in the power steering system.




U0129/42 is not output

2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)

U0129/42 is output

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)
a.

Check for brake control system DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRAC > Trouble Codes
50001 105
Result:
Proceed to
Brake control system DTC is not output.
Brake control system DTC is output.




Brake control system DTC is not output.

REPLACE POWER STEERING ECU ASSEMBLY

Brake control system DTC is output.

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)