Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU
RM30B0U _55 Steering _010121 POWER ASSIST SYSTEMS _0054953 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing the steering column (Click here Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.REMOVE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY

Hide 6.REMOVE POWER STEERING ECU ASSEMBLY

a.
C275623

Remove the ECU wire sub-assembly from the power steering ECU assembly.


b.
C275624

Detach the 2 claws and remove the power steering ECU protector from the power steering ECU assembly.


c.
C275625

Detach the 4 claws and remove the power steering ECU protector from the power steering ECU assembly.


d.
C275626

Remove the 3 terminal bolts, 2 bolts and power steering ECU assembly from the steering column sub-assembly.