A bolt without a torque specification is shown in the standard bolt chart Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS.
1.INSTALL AUTOMATIC LIGHT CONTROL SENSOR (SOLAR SENSOR)
Attach the 2 claws to install the automatic light control sensor (solar sensor).
Connect the connector.
2.INSTALL UPPER INSTRUMENT PANEL ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.CHECK SRS WARNING LIGHT