1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE UPPER INSTRUMENT PANEL ASSEMBLY
4.REMOVE AUTOMATIC LIGHT CONTROL SENSOR (SOLAR SENSOR)
Disconnect the connector.
Detach the 2 claws and remove the automatic light control sensor (solar sensor).