Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE FRONT SEAT ASSEMBLY LH
4.REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD LH
5.REMOVE FRONT SEAT CUSHION SHIELD LH
6.REMOVE FRONT INNER SEAT CUSHION SHIELD LH
7.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
8.REMOVE FRONT SEAT HEADREST SUPPORT
9.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
10.REMOVE SEPARATE TYPE FRONT SEATBACK PAD
11.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH
Detach the 2 clamps from the front seatback frame sub-assembly.
The nuts must not be reused.
Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
Remove the 2 nuts and front seat airbag assembly LH.