Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR
RM30B0U _58 Vehicle Interior _010074 SUPPLEMENTAL RESTRAINT SYSTEMS _0055020 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 4.REMOVE DECK BOARD ASSEMBLY (for Compact Spare Tire)

Hide 5.REMOVE DECK BOARD ASSEMBLY (for Full Size Spare Tire)

Hide 7.REMOVE REAR FLOOR FINISH PLATE (for Compact Spare Tire)

Hide 8.REMOVE REAR DECK TRIM COVER (for Full Size Spare Tire)

Hide 9.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (for Compact Spare Tire)

Hide 10.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (for Full Size Spare Tire)

Hide 11.REMOVE REAR DOOR SCUFF PLATE LH

Hide 12.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 13.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 14.REMOVE REAR AIRBAG SENSOR LH

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Disconnect the connector from the rear airbag sensor LH.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push the housing lock and slide the outer housing. (At this time, the connector cannot be disconnected yet.)


ii.

Push the housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting.


C195226
1.083,1 0.906,0.563 true 3.604,1 3.427,0.563 true 4.094,1.76 3.917,1.323 true 1.552,1.76 1.375,1.323 true 0.917,1.156 0.583,0.646 true 0.802,0.375 1.115,0.531 0.313,0.156 10 *1 4.063,1.802 4.375,1.958 0.313,0.156 10 *2 3.313,0.375 3.625,0.531 0.313,0.156 10 *1 1.521,1.792 1.833,1.948 0.313,0.156 10 *2 0.438,0.417 0.896,0.615 0.458,0.198 10 (A)
*1 Housing Lock *2 Outer Housing




d.
B339278

Remove the nut and rear airbag sensor LH.

NOTICE:

Loosen the nut while holding the rear airbag sensor LH because the rear airbag sensor pin (stopper) is easily damaged.