Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM30B0U _59 Vehicle Exterior _009987 SLIDING ROOF / CONVERTIBLE _0056327 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  REMOVAL  


PROCEDURE

Hide 1.REMOVE ROOF HEADLINING ASSEMBLY

Hide 2.REMOVE SLIDING ROOF SIDE GARNISH LH

a.
B338922

Detach the 2 claws and remove the sliding roof side garnish LH.


Hide 3.REMOVE SLIDING ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 4.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY

a.
B338923

Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

NOTICE:

To prevent the sliding roof glass and sliding roof drive gear from being displaced, fully close the sliding roof glass (sliding roof drive cable), and then remove the sliding roof glass sub-assembly.



Hide 5.REMOVE SLIDING ROOF WEATHERSTRIP

a.

Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.


Hide 7.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 8.REMOVE REAR SIDE RAIL SPACER LH

Hide 9.REMOVE REAR SIDE RAIL SPACER RH

HINT:

Use the same procedure as for the LH side.


Hide 10.REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY

a.
B338924

Detach the claw and disconnect the sliding roof drain hose.

HINT:

Use the same procedure for the other 3 sliding roof drain hoses.



b.

Loosen the 8 bolts on the sliding roof housing side.

NOTICE:

Do not remove the bolts.


B341375


c.

Remove the 8 bolts on the vehicle interior side.


d.

Remove the 8 nuts and sliding roof housing sub-assembly.

B341377