This DTC is stored when a malfunction occurs in the stereo component amplifier assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15A3 | Stereo Component Amplifier Malfunction | When one of the conditions below is met:
·
Internal power supply malfunction ·
DSP error ·
EEPROM error |
·
Stereo component amplifier assembly ·
Radio and display receiver assembly |
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTCs are output
Replace the stereo component amplifier assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
DTCs are output