This DTC is stored when a malfunction occurs in the speakers.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C3 | Speaker Output Short | A short is detected in the speaker output circuit. | ·
Harness or connector ·
Speakers ·
Stereo component amplifier assembly ·
Radio and display receiver assembly |
*1: for LH Side
*2: for RH Side
Disconnect the M23 stereo component amplifier assembly connector.
Disconnect the J1*1 and/or I1*2 front No. 1 speaker assembly connector.
Disconnect the H2*1 and/or H4*2 front No. 2 speaker assembly connector.
Disconnect the L2*1 and/or K2*2 rear speaker assembly connector.
Disconnect the N4 woofer box speaker assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M23-14 (FL+) - J1-1 | Always | Below 1 Ω |
| M23-29 (FL-) - J1-2 | Always | Below 1 Ω |
| M23-10 (TWL+) - H2-4(TWL+) | Always | Below 1 Ω |
| M23-25 (TWL-) - H2-3(TWL-) | Always | Below 1 Ω |
| M23-11 (RL+) - L2-1(+) | Always | Below 1 Ω |
| M23-26 (RL-) - L2-2(-) | Always | Below 1 Ω |
| M23-14 (FL+) - Body ground | Always | 10 kΩ or higher |
| M23-29 (FL-) - Body ground | Always | 10 kΩ or higher |
| M23-10 (TWL+) - Body ground | Always | 10 kΩ or higher |
| M23-25 (TWL-) - Body ground | Always | 10 kΩ or higher |
| M23-11 (RL+) - Body ground | Always | 10 kΩ or higher |
| M23-26 (RL-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M23-9 (FR+) - I1-1 | Always | Below 1 Ω |
| M23-24 (FR-) - I1-2 | Always | Below 1 Ω |
| M23-13 (TWR+) - H4-4(TWR+) | Always | Below 1 Ω |
| M23-28 (TWR-) - H4-3(TWR-) | Always | Below 1 Ω |
| M23-12 (RR+) - K2-1(+) | Always | Below 1 Ω |
| M23-27 (RR-) - K2-2(-) | Always | Below 1 Ω |
| M23-9 (FR+) - Body ground | Always | 10 kΩ or higher |
| M23-24 (FR-) - Body ground | Always | 10 kΩ or higher |
| M23-13 (TWR+) - Body ground | Always | 10 kΩ or higher |
| M23-28 (TWR-) - Body ground | Always | 10 kΩ or higher |
| M23-12 (RR+) - Body ground | Always | 10 kΩ or higher |
| M23-27 (RR-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M23-15 (WFR+) - N4-1 (WF+) | Always | Below 1 Ω |
| M23-30 (WFR-) - N4-2 (WF-) | Always | Below 1 Ω |
| M23-8 (WFL+) - N4-3 (WF+) | Always | Below 1 Ω |
| M23-23 (WFL-) - N4-4 (WF-) | Always | Below 1 Ω |
| M23-15 (WFR+) - Body ground | Always | 10 kΩ or higher |
| M23-30 (WFR-) - Body ground | Always | 10 kΩ or higher |
| M23-8 (WFL+) - Body ground | Always | 10 kΩ or higher |
| M23-23 (WFL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the J1*1 and/or I1*2 front No. 1 speaker assembly connector.
*1: for LH Side
*2: for RH Side
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
Connect all the connectors to the front No. 2 speaker assemblies that were disconnected.
When there is a possibility that either the right or left speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
DTCs are output
Replace the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
Connect all the connectors to the rear speaker assemblies that were disconnected.
When there is a possibility that either the right or left speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
DTCs are output
Remove the woofer box speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>REMOVAL
Inspect the woofer box speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the stereo component amplifier assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
DTCs are output