The speed sensor detects the wheel speed and sends the appropriate signals to the brake actuator assembly (skid control ECU). The brake actuator assembly (skid control ECU) converts these wheel speed signals into a 4-pulse signal and outputs it to the ECM via the combination meter assembly. The ECM determines the vehicle speed based on the frequency of this pulse signal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0500 | Vehicle Speed Sensor Malfunction | The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while the cruise control is in operation. | ·
Vehicle speed sensor ·
Vehicle speed sensor signal circuit ·
Combination meter assembly ·
ECM |
This DTC may be stored under the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC P0500 is not output |
| DTC P0500 is output |
DTC P0500 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC P0500 is output