Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM30B0U _54 Brake _010843 BRAKE SYSTEM (OTHER) _0057927 BRAKE MASTER CYLINDER A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



PROCEDURE

Hide 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Install a new O-ring to the master cylinder.


b.

Install the master cylinder to the booster with the 2 nuts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


c.
C211024
2.458,0.802 2.573,0.948 0.115,0.146 10 false A 2.208,1.667 2.375,1.906 0.167,0.24 10 false B 1.927,0.917 2.094,1.125 0.167,0.208 10 false B

Using a union nut wrench, connect the 2 brake lines labeled B to the master cylinder.

Torque:
15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.

Connect the brake fluid level warning switch connector labeled A to the brake master cylinder.


Hide 2.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 3.BLEED BRAKE SYSTEM