Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER
RM30B0U _54 Brake _010843 BRAKE SYSTEM (OTHER) _0057928 BRAKE BOOSTER A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 4.REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY

a.
C278610

Disengage the 3 clips and remove the cowl ventilator housing sub-assembly.


Hide 5.REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY

a.
C278592

Remove the 13 bolts and cowl top panel outer sub-assembly.


Hide 6.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

a.
C212147

Remove the 2 nuts and cowl body mounting reinforcement LH.


Hide 7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 8.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 10.REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET

Hide 11.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 12.DISCONNECT VACUUM HOSE

a.

Slide the clip and disconnect the vacuum hose.


Hide 13.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 14.REMOVE BRAKE PEDAL RETURN SPRING

Hide 15.REMOVE PUSH ROD PIN

Hide 16.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the push rod clevis lock nut.


b.

Remove the push rod clevis.


Hide 17.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C126454

Remove the 4 nuts.


b.

Pull out the brake booster with the brake booster gasket.

NOTICE:

Do not damage the brake lines.



Hide 18.REMOVE BRAKE BOOSTER GASKET

Hide 19.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

a.

Remove the brake vacuum check valve assembly from the brake booster.


Hide 20.REMOVE CHECK VALVE GROMMET

a.

Remove the check valve grommet from the brake booster.