Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE
RM30B0U _54 Brake _010845 BRAKE (REAR) _0057933 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.INSTALL REAR FLEXIBLE HOSE LH

NOTICE:

When replacing both the left and right rear flexible hoses, as the left and right hoses each have a different shape, be sure to check the part number to confirm whether the hose is the left or right one before installing it.


a.

Connect the flexible hose with a new gasket and a new union bolt to the disc brake cylinder.

Torque:
39.2 N*m (400 kgf*cm, 29 ft.*lbf)

HINT:

Install the flexible hose lock securely in the lock hole in the cylinder.



b.
C129063
2.958,0.698 3.115,0.865 0.156,0.167 10 A 2.26,0.781 2.396,0.948 0.135,0.167 10 B

Set the flexible hose into place at the connecting point with the brake tube labeled A, and then install a new clip labeled B.


c.

Using a union nut wrench, connect the flexible hose to the brake tube labeled A while holding the flexible hose with a wrench.

Torque:
15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 2.REMOVE COWL TOP VENTILATOR LOUVER BRACKET LH

Hide 4.INSTALL COWL TOP VENTILATOR LOUVER BRACKET LH

Hide 5.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)