Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR(for 2WD)
RM30B0U _54 Brake _010842 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0057935 REAR SPEED SENSOR(for 2WD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for 2WD)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

a.

Remove the deck trim side panel LH (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).

HINT:

Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel LH.



Hide 3.REMOVE SKID CONTROL SENSOR WIRE

a.
C127328

Disconnect the skid control sensor wire connector.


b.
C278575

Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.


c.
C278576
2.104,0.583 2.26,0.781 0.156,0.198 10 B 3.021,0.427 3.188,0.625 0.167,0.198 10 A 0.438,2.375 0.594,2.573 0.156,0.198 10 D 1.208,2.896 1.365,3.094 0.156,0.198 10 C 1.771,2.635 1.927,2.833 0.156,0.198 10 D 2.594,2.375 2.75,2.573 0.156,0.198 10 C

Remove the bolt labeled A and sensor clamp labeled B from the side member.


d.

Remove the 2 nuts labeled C and 2 sensor clamps labeled D from the upper arm.


e.
C278577
1.354,2.031 1.521,2.229 0.167,0.198 10 G 2.781,1.594 2.906,1.771 0.125,0.177 10 F 2.792,2.5 2.938,2.719 0.146,0.219 10 E

Remove the bolt labeled E and sensor clamp labeled F from the carrier.


f.

Disconnect the skid control sensor wire connector labeled G from the skid control sensor.


Hide 4.REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH

Hide 5.REMOVE REAR DISC

Hide 6.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)