Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM30B0U _54 Brake _010842 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0057937 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

a.

Install the spiral cable with steering angle sensor (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION).

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with the battery connected and the ignition switch ON.

·

w/ Vehicle Stability control System:

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

·

Do not remove the steering angle sensor from the spiral cable.




Hide 2.INSTALL STEERING COLUMN COVER

Hide 3.INSTALL STEERING WHEEL ASSEMBLY

Hide 5.INSPECT STEERING WHEEL CENTER POINT

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).