The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
Refer to ABS Warning Light Remains ON.
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
DTC is not output
DTC is output
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the A64 skid control ECU (brake actuator assembly) connector.
Turn the ignition switch to ON.
Check that the ABS warning light comes on.
The ABS warning light comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the A64 skid control ECU (brake actuator assembly) connector.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light | Warning light OFF/ON | Observe combination meter
Vehicle condition: Vehicle stopped |
When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ABS Warning Light | ABS warning light | OFF or ON | OFF: Warning light off
ON: Warning light on |
- |
| Active Test Display |
|---|
| ABS Warning Light |
| Data List Display |
|---|
| ABS Warning Light |
| Result | Proceed to |
|---|---|
| ABS warning light in the Data List does not change using the Active Test | A |
| ABS warning light in the Data List turns ON/OFF using the Active Test | B |
A
B
Turn the ignition switch off.
Perform Active Test of the combination meter assembly using the Techstream.
| Tester Display |
|---|
| Indicat. Lamp ABS |
Check the combination meter assembly.
The ABS warning light turns on or off in accordance with the Techstream.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING