Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM30B0U _54 Brake _010842 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0058073 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  Brake Warning Light does not Come ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM

Result:
Proceed to
DTC is not output
DTC is output




DTC is not output

2.CHECK BRAKE WARNING LIGHT

DTC is output

2.CHECK BRAKE WARNING LIGHT
a.

Disconnect the A64 skid control ECU (brake actuator assembly) connector.


b.

Turn the ignition switch to ON.


c.

Check that the brake warning light comes on.


OK:

The brake warning light comes on.


Result:
Proceed to
OK
NG



OK

NG

3.PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT)
3.PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT)
a.

Turn the ignition switch off.


b.

Reconnect the A64 skid control ECU (brake actuator assembly) connector.


c.

Connect the Techstream to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the Techstream on.


f.

Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.


g.

According to the display on the Techstream, perform the Active Test.


Chassis > ABS/VSC/TRAC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Brake Warning Light Brake warning light Warning light OFF/ON Observe combination meter
Vehicle condition: Vehicle stopped
h.

When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.


Chassis > ABS/VSC/TRAC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Brake Warning Light Brake warning light OFF or ON OFF: Warning light off
ON: Warning light on
-
Chassis > ABS/VSC/TRAC > Active Test
Active Test Display
Brake Warning Light
Data List Display
Brake Warning Light
50004 105 12 52
Result:
Result Proceed to
Brake warning light in the Data List does not change using the Active Test A
Brake warning light in the Data List turns ON/OFF using the Active Test B



A

B

4.INSPECT COMBINATION METER ASSEMBLY
4.INSPECT COMBINATION METER ASSEMBLY
a.

Turn the ignition switch off.


b.

Perform Active Test of the combination meter assembly using the Techstream.

Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Brake
50004 122 21

c.

Check the combination meter assembly.


OK:

The brake warning light turns on or off in accordance with the Techstream.


Result:
Proceed to
OK
NG



OK

NG