Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM30B0U _54 Brake _010842 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0058073 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1442  Invalid Data Received from Acceleration Sensor  C1443  Invalid Data Received from Yaw Rate Sensor  


DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor.

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1442 Invalid Data Received from Acceleration Sensor Both of the following is condition is met.
1.

With the IG1 terminal voltage between 9.5 and 17.4 V.

2.

An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.


Acceleration sensor (Airbag sensor assembly)
C1443 Invalid Data Received from Yaw Rate Sensor Both of the following is condition is met.
1.

With the IG1 terminal voltage between 9.5 and 17.4 V.

2.

An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more.


Yaw rate sensor (Airbag sensor assembly)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK DTC

Chassis > ABS/VSC/TRAC > Clear DTCs
50002 105
b.

Turn the ignition switch off.


c.

Start the engine and idle it for 60 seconds, and then stop the engine.



Chassis > ABS/VSC/TRAC > Trouble Codes
50001 105
Result:
Proceed to
DTCs C1442 and/or C1443 are output
DTCs C1442 and C1443 are not output



DTCs C1442 and/or C1443 are output

DTCs C1442 and C1443 are not output