The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from the speed sensors.
These signals are used for recognizing that all 4 wheels are operating properly.
Therefore, all wheel signals must indicate the same speed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1337 | Diameter of the Tire is not Uniform | The following occurs in 3 consecutive trips:
At a vehicle speed of 20 km/h (12 mph) or more, there is a 20% difference or more in the average speed between the front wheels and rear wheels for 20 seconds or more. |
·
Tire and wheel size ·
Tire deformation ·
Speed sensor rotor ·
Speed sensor ·
Speed sensor circuit ·
Skid control ECU (Brake actuator assembly) |
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
When C1401 to C1408 and/or C1413 to C1416 are output with C1337, inspect and repair the trouble areas indicated by C1401 to C1408 and/or C1413 to C1416 first.
Check the size and condition of all 4 wheels.
The DTC is output when tire deformation or a difference in tire size is detected.
The diameter of all 4 tires and air pressure are the same.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC C1337 is output |
| DTC C1337 is not output |
DTC C1337 is output
DTC C1337 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING