1.INSTALL ANTENNA CORD SUB-ASSEMBLY
w/ Navigation System or w/ Satellite Radio:
Attach the 6 clamps to install the antenna cord sub-assembly.
w/o Navigation System:
Attach the 4 clamps to install the antenna cord sub-assembly.
Attach the claw.
Connect each connector.
2.INSTALL UPPER INSTRUMENT PANEL
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.CHECK SRS WARNING LIGHT