1.REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)
2.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
3.REMOVE DECK BOARD ASSEMBLY (for Compact Spare Tire)
4.REMOVE DECK BOARD ASSEMBLY (for Full Size Spare Tire)
5.REMOVE DECK FLOOR BOX LH
6.REMOVE REAR FLOOR FINISH PLATE (for Compact Spare Tire)
7.REMOVE REAR DECK TRIM COVER (for Full Size Spare Tire)
8.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
for Compact Spare:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
for Full Size Spare Tire:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
9.REMOVE REAR SEAT ASSEMBLY
for LH:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY(for LH Side)>REMOVAL
for RH:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY(for RH Side)>REMOVAL
10.REMOVE REAR DOOR SCUFF PLATE LH
11.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
12.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
13.REMOVE RADIO SETTING CONDENSER
When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.
Remove the bolt.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.
Using a screwdriver, bend back and break off the claw as shown in the illustration.
Remove the terminal cover from the wire harness.
Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.
Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.
Check for deformation of the terminal after the wire harness has been removed from the terminal cover.