Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0058387 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL RADIO SETTING CONDENSER

a.
E270056

Attach the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.




b.
E270057

Attach the 3 claws to install the new terminal cover with wire harness to a new condenser.

NOTICE:
·

Do not use excessive force when inserting the terminal cover into the condenser.

·

If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.




c.

Attach the clamp to temporarily install a new radio setting condenser with wire harness.


d.

Install the new radio setting condenser with the bolt.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 3.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 4.INSTALL REAR DOOR SCUFF PLATE LH

Hide 6.INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE

Hide 7.INSTALL REAR DECK TRIM COVER (for Full Size Spare Tire)

Hide 8.INSTALL REAR FLOOR FINISH PLATE (for Compact Spare Tire)

Hide 11.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 12.INSTALL PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)