1.REMOVE REAR BUMPER COVER
2.REMOVE NO. 2 LUGGAGE ROOM WIRE
Disconnect the 4 connectors.
Detach the 6 clamps and remove the No. 2 luggage room wire.
3.REMOVE NO. 3 ULTRASONIC SENSOR
Detach the 4 claws and remove the No. 3 ultrasonic sensor as shown in the illustration.
The illustration shows the No. 3 ultrasonic sensor for the LH corner and back sensor RH. The horizontal orientation of the No. 3 ultrasonic sensor for the RH corner and back sensor LH is opposite that of the image shown in the illustration.
Use the same procedure for all No. 3 ultrasonic sensors.