Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH
RM30B0U _56 Audio / Visual / Telematics _009404 PARK ASSIST / MONITORING _0058391 CLEARANCE SONAR MAIN SWITCH A

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time maybe required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 4.REMOVE TELLTALE LIGHT ASSEMBLY (CLEARANCE SONAR MAIN SWITCH)

a.
B337767

Detach the 2 clips and claw and remove the telltale light assembly (clearance sonar main switch).


b.
B337768

Disconnect the connector.