1.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Remove the transmission control shaft lever.
Click hereDrivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>PARK / NEUTRAL POSITION SWITCH>REMOVAL
Loosen the 2 bolts of the park/neutral position switch assembly.
| *a | Protrusion |
Align the protrusions of the park/neutral position switch assembly.
Hold the park/neutral position switch assembly in position and tighten the 2 bolts.
After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the switch are aligned.
Install the transmission control shaft lever.
Click hereDrivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>PARK / NEUTRAL POSITION SWITCH>INSTALLATION
After the adjustment, perform the switch operation check.