1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure toread the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
4.REMOVE BATTERY CLAMP SUB-ASSEMBLY
5.REMOVE BATTERY INSULATOR
6.REMOVE BATTERY
7.REMOVE BATTERY TRAY
8.REMOVE FRONT BATTERY BRACKET
9.REMOVE BATTERY BRACKET REINFORCEMENT
10.DRAIN ENGINE COOLANT
11.DRAIN AUTOMATIC TRANSAXLE FLUID
12.REMOVE TRANSMISSION OIL COOLER
Slide the clips and remove the oil cooler inlet hose and oil cooler outlet hose.
Detach the 3 clamps from the No. 8 water by-pass hose and No. 9 water by-pass hose.
Slide the clips and remove the No. 8 water by-pass hose and No. 9 water by-pass hose.
Remove the 2 bolts and transmission oil cooler from the front engine mounting bracket.