1.REMOVE CONSOLE BOX ASSEMBLY
2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the shift lever assembly.
| *1 | Stopper |
| *2 | Nut |
Pull out the stopper of the transmission control cable assembly.
Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.
Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.
3.REMOVE SHIFT LEVER ASSEMBLY
Disconnect the 2 connectors and 4 clamps from the shift lever assembly.
Remove the 4 bolts and shift lever assembly.