Home › Drivetrain › U760F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE FLUID
RM30B0U _52 Drivetrain _009030 U760F AUTOMATIC TRANSMISSION / TRANSAXLE _0058574 AUTOMATIC TRANSAXLE FLUID A

U760F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE AUTOMATIC TRANSAXLE FLUID

a.

Lift the vehicle. [*1]

NOTICE:

Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle from the front to rear of the vehicle is within +/- 1°).



b.

Remove the No. 1 engine under cover.

Click hereEngine / Hybrid System>2AR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL


c.

Remove the rear engine under cover LH.

Click hereEngine / Hybrid System>2AR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL


d.
C205875

Remove the refill plug and gasket from the automatic transaxle. [*2]


e.
C205876

Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle. [*3]


f.
C162883
0.833,2.625 1.792,2.625 false 0.885,3.49 1.781,3.49 false 0.667,3.167 0.292,4.094 0.292,4.094 1.177,4.094 true 1.833,2.531 2.042,2.688 0.208,0.156 10 *1 1.25,4.01 1.427,4.188 0.177,0.177 10 *a 1.833,3.406 2.031,3.635 0.198,0.229 10 *2
*1 No. 1 Transmission Oil Filler Tube
*2 Hexagon Socket Wrench
*a Overflow Plug Hole


Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the oil pan and drain the automatic transaxle fluid. [*4]


g.
C239510

Measure the amount of fluid that you drained. [*5]

HINT:

Add the same amount of fluid in step [*8].



h.

Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the oil pan. [*6]

Torque:
0.8 N*m (8 kgf*cm, 7 in.*lbf)


i.
C205876

Temporarily install the gasket and the overflow plug. [*7]

HINT:

Reuse the old gasket. The plug will be removed again to adjust the fluid level.



j.
C239936

Add fluid to the refill hole using the same amount of fluid drained in step [*5]. [*8]

NOTICE:

Use Toyota Genuine ATF WS.



k.
C205875

Temporarily install the gasket and refill plug to avoid fluid spillage. [*9]

HINT:

Reuse the old gasket. The plug will be removed again to adjust the fluid level.



l.

Lower the vehicle. [*10]


m.

Start the engine. [*11]


n.

Slowly move the shift lever from P to D, and then back to P. [*12]


o.

Allow the engine to idle for 30 seconds to warm it up. [*13]


p.

Turn the ignition switch off. [*14]


q.

Repeat steps [*1] to [*14].


r.

Repeat steps [*1] to [*10].