Home › Drivetrain › U760F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL COOLER
RM30B0U _52 Drivetrain _009030 U760F AUTOMATIC TRANSMISSION / TRANSAXLE _0058579 OIL COOLER A

U760F AUTOMATIC TRANSMISSION / TRANSAXLE  OIL COOLER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure toread the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 4.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 5.REMOVE BATTERY INSULATOR

Hide 6.REMOVE BATTERY

Hide 7.REMOVE BATTERY TRAY

Hide 8.REMOVE FRONT BATTERY BRACKET

Hide 9.REMOVE BATTERY BRACKET REINFORCEMENT

Hide 12.REMOVE TRANSMISSION OIL COOLER

a.
C280046

Slide the clips and remove the oil cooler inlet hose and oil cooler outlet hose.


b.
C280047

Detach the 3 clamps from the No. 8 water by-pass hose and No. 9 water by-pass hose.


c.

Slide the clips and remove the No. 8 water by-pass hose and No. 9 water by-pass hose.


d.
C280048

Remove the 2 bolts and transmission oil cooler from the front engine mounting bracket.