Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR(for AWD)
RM30B0U _54 Brake _010842 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0060233 REAR SPEED SENSOR(for AWD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for AWD)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

a.

Remove the deck trim side panel LH (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).

HINT:

Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel assembly LH.



Hide 3.REMOVE REAR SPEED SENSOR LH

a.
C127328

Disconnect the speed sensor connector.


b.
C274701

Disconnect the grommet of the speed sensor wire from the hole of the wheel house.


c.
C274702
2.104,0.583 2.26,0.781 0.156,0.198 10 B 3.042,0.438 3.198,0.635 0.156,0.198 10 A 2.604,2.365 2.76,2.563 0.156,0.198 10 C 1.771,2.625 1.927,2.823 0.156,0.198 10 D 0.438,2.365 0.594,2.563 0.156,0.198 10 D 1.219,2.917 1.375,3.115 0.156,0.198 10 C

Remove the bolt labeled A and sensor clamp labeled B from the side member.


d.

Remove the 2 nuts labeled C and sensor clamps labeled D from the upper arm.


e.
C274703
0.458,3.021 0.615,3.219 0.156,0.198 10 E 2.417,2.396 2.573,2.594 0.156,0.198 10 F 2.771,1.823 2.927,2.021 0.156,0.198 10 G 1.958,1.521 2.115,1.719 0.156,0.198 10 H

Remove the nut labeled E and sensor clamp labeled F from the trailing arm.


f.

Remove the bolt labeled G and sensor body labeled H from the carrier.

NOTICE:

Keep the sensor tip and sensor installation hole free from foreign matter.