1.DRAIN DIFFERENTIAL OIL
2.REMOVE REAR WHEEL
3.REMOVE FUEL TANK ASSEMBLY
4.REMOVE EXHAUST PIPE ASSEMBLY
5.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
6.REMOVE REAR SUSPENSION MEMBER BRACE LH
Remove the 2 bolts and brace from the suspension member.
7.REMOVE REAR SUSPENSION MEMBER BRACE RH
Use the same procedure described for the LH side.
8.REMOVE REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY
Disconnect the 2 harness clamps.
Disconnect the connector.
Remove the bolt and wire harness clamp bracket.
Remove the breather tube.
Support the rear differential carrier sub-assembly with a transmission jack or equivalent.
Remove the 2 bolts labeled A and bolt labeled B.
Slowly lower the jack and then tilt the rear differential carrier sub-assembly.
9.REMOVE REAR DRIVE SHAFT ASSEMBLY LH
10.REMOVE REAR DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.
11.REMOVE REAR NO. 1 AND NO. 2 DIFFERENTIAL SUPPORT
Remove the 4 bolts and rear No. 1 and No. 2 differential supports from the rear differential carrier.
12.REMOVE REAR DIFFERENTIAL SUPPORT
Remove the 4 bolts and rear differential support from the rear differential carrier sub-assembly.