1.INSTALL REAR DIFFERENTIAL SUPPORT
Install the rear differential support to the differential carrier sub-assembly with a new 4 bolts.
2.INSTALL REAR NO. 1 AND NO. 2 DIFFERENTIAL SUPPORT
Install the rear No. 1 and No. 2 differential supports with a new 4 bolts to the differential carrier sub-assembly.
3.INSTALL REAR DRIVE SHAFT ASSEMBLY LH
4.INSTALL REAR DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.
5.INSTALL DIFFERENTIAL CARRIER SUB-ASSEMBLY
Support the rear differential carrier with a transmission jack or equivalent.
Slowly raise the transmission jack, and install the 3 bolts.
Tighten the bolts, not the nuts.
Install a new bolt (labeled B).
Install the breather tube.
Install the wire harness clamp bracket with the bolt.
Connect the connector.
Connect the 2 harness clamps.
6.INSTALL REAR SUSPENSION MEMBER BRACE LH
Install the member brace with the 2 bolts to the suspension member.
7.INSTALL REAR SUSPENSION MEMBER BRACE RH
Use the same procedure described for the LH side.
8.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
9.INSTALL EXHAUST PIPE ASSEMBLY
10.INSTALL FUEL TANK ASSEMBLY
11.ADD DIFFERENTIAL OIL