Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH
2.REMOVE OUTER MIRROR COVER LH
3.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
4.REMOVE LOWER OUTER MIRROR COVER LH (except TMMC Made)
| *1 | Tape |
Remove the tape.
Detach the 5 guides.
Detach the 5 claws to remove the lower outer mirror cover LH.
5.REMOVE OUTER MIRROR RETRACTOR LH (except TMMC Made)
| *a | Cut the harness sub-assembly here |
Cut the harness sub-assembly at the position shown in the illustration.
Make sure to replace the harness sub-assembly with a new one.
Remove the gasket sub-assembly from the outer rear view mirror assembly LH.
Using a T25 "TORX" socket wrench, remove the 3 screws.
Make sure to replace the "TORX" screws with new ones.
Remove the 2 screws and frame sub-assembly as shown in the illustration.
Disconnect the connector.
Remove the harness sub-assembly from the frame sub-assembly.
Remove the 4 screws and support.