Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0060876 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

a.
B277362
1.542,1.231 1.729,1.392 0.187,0.162 10 *1 1.751,1.326 2.492,1.326 false
Text in illustration
*1 String


Tie the string that was passed through the engine compartment room to the end of the hood lock control cable assembly as shown in the illustration.

HINT:

Use a length of string long enough to pass through the engine compartment room.



b.

Pass the hood lock control cable assembly through the vehicle body, and then attach each clamp.


c.

Untie the string from the hood lock control cable assembly.

B338124
5.75,5.25 6.344,5.042 true 3.208,5.396 2.646,5.51 true 5.042,5.625 4.708,5.469 true 0.99,4.583 1.552,4.313 true 0.646,4.073 1.24,3.792 true 0.813,2.042 0.813,1.313 true 4.552,4.99 5.063,4.656 true 6.802,5.656 6.802,5.104 true 5.094,5.563 5.302,5.76 0.208,0.198 10 *1 6.75,5.656 7.073,5.823 0.323,0.167 10 *2 0.75,1.146 0.958,1.344 0.208,0.198 10 *1 0.469,4.021 0.677,4.219 0.208,0.198 10 *1 0.823,4.521 1.031,4.719 0.208,0.198 10 *1 2.479,5.448 2.688,5.646 0.208,0.198 10 *1 5.604,5.188 5.813,5.385 0.208,0.198 10 *1 5.094,4.552 5.26,4.771 0.167,0.219 10 *2
Text in illustration
*1 Hood Lock Control Cable *2 Stopper



Hide 2.INSTALL HOOD LOCK ASSEMBLY

a.

Apply MP grease to the sliding parts of the hood lock assembly.


b.

Connect the hood lock control cable to the hood lock assembly.


c.

Install the hood lock assembly with the 3 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.


b.

Attach the 3 claws to install the hood lock control lever sub-assembly.


Hide 7.INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY

Hide 8.INSTALL HOOD TO FRONT FENDER SEAL RH

B340664

a.

Attach the 3 clips to install the hood to front fender seal RH.


b.

Install the clip.


Hide 9.INSTALL HOOD TO FRONT FENDER SEAL LH

HINT:

Use the same procedure described for the RH side.


Hide 10.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY