Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0060914 LANE DEPARTURE ALERT SWITCH A

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 4.REMOVE TELLTALE LAMP ASSEMBLY (LANE DEPARTURE ALERT SWITCH)

a.
B337767

Detach the 2 clips and claw.


b.
B337768

Disconnect the connector to remove the telltale light assembly (lane departure alert switch).