Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0060914 LANE DEPARTURE ALERT SWITCH A

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL TELLTALE LIGHT ASSEMBLY (LANE DEPARTURE ALERT SWITCH)

a.

Connect the connector.


b.

Attach the claw and 2 clips to install the telltale light assembly (lane departure alert switch).


Hide 2.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION