The multiplex network door ECU receives signals from the latch switch, sector switch and back door courtesy switch, which are built into the back door lock assembly. Based on these switch signals, the latch position of the back door lock assembly is determined.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2251 | Back Door Closer Switch Malfunction | While the back door closer is operating, a malfunction is detected in position information from the back door courtesy switch within a specified amount of time. | ·
Back door lock assembly ·
Harness or connector ·
Multiplex network door ECU |
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the Data List for proper functioning of the back door courtesy switch.
Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR CLOSER SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Courtesy SW | Back door courtesy switch signal | ON or OFF | ON: Back door open
OFF: Back door closed |
- |
| Tester Display |
|---|
| Courtesy SW |
The display is as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the back door lock assembly.
Inspect the back door lock assembly.
Click hereVehicle Interior>DOOR LOCK>BACK DOOR LOCK>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the U13 back door lock assembly connector.
Disconnect the U18 multiplex network door ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U13-3 (CTY) - U18-19 (FUL) | Always | Below 1 Ω |
| U13-4 (E) - Body ground | Always | Below 1 Ω |
| U13-3 (CTY) or U18-19 (FUL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG