Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER ECU
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0061409 BACK DOOR CLOSER ECU A

DOOR / HATCH  BACK DOOR CLOSER ECU  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) is memorized, so be sure to make a note of the automatic open stop position.


PROCEDURE

Hide 1.REMOVE BACK DOOR CENTER GARNISH

Hide 2.REMOVE BACK DOOR SIDE GARNISH LH

Hide 3.REMOVE BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure described for the LH side.


Hide 4.REMOVE BACK DOOR TRIM BOARD ASSEMBLY

Hide 5.REMOVE MULTIPLEX NETWORK DOOR ECU

a.
B336830

Disconnect the 2 connectors.


b.

Remove the 2 bolts.


c.

Detach the clamp and guide and remove the multiplex network door ECU.