Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0061403 POWER BACK DOOR SYSTEM C

DOOR / HATCH  POWER BACK DOOR SYSTEM  B2229  PBD Unit Motor RH Circuit  


DESCRIPTION

This DTC is output when the multiplex network door ECU detects a power back door unit assembly set RH motor malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2229 PBD Unit Motor RH Circuit This DTC is output when the multiplex network door ECU detects a power back door unit assembly set RH motor malfunction.
·

Multiplex network door ECU

·

Power back door unit assembly set RH

·

Harness or connector



WIRING DIAGRAM

B341468
1.042,1.583 1.5,1.781 0.458,0.198 10 U19 1.021,1.75 5,1.948 3.979,0.198 10 Multiplex Network Door ECU 4.333,1.583 4.792,1.781 0.458,0.198 10 U20 4.333,1.75 5.75,2.083 1.417,0.333 10 Power Back Door Unit Assembly Set RH 2.083,0.552 2.542,0.75 0.458,0.198 10 BD+2 2.083,1.083 2.542,1.281 0.458,0.198 10 BD-2 4.458,1.083 4.917,1.281 0.458,0.198 10 BD-2 4.458,0.583 4.917,0.781 0.458,0.198 10 BD+2 2.542,0.417 3,0.615 0.458,0.198 10 2 2.542,0.969 3,1.167 0.458,0.198 10 1 4.167,0.417 4.625,0.615 0.458,0.198 10 1 4.167,0.969 4.625,1.167 0.458,0.198 10 2

PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Back Door > Clear DTCs
50002 159

b.

Check for DTCs.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Back Door > Trouble Codes
50001 159

Result:
Proceed to
DTC B2229 is not output
DTC B2229 is output



DTC B2229 is not output

DTC B2229 is output

2.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - POWER BACK DOOR UNIT ASSEMBLY SET RH)
2.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - POWER BACK DOOR UNIT ASSEMBLY SET RH)
a.

Disconnect the U19 multiplex network door ECU connector.


b.

Disconnect the U20 power back door unit assembly set RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
U19-2 (BD+2) - U20-1 (BD+2) Always Below 1 Ω
U19-1 (BD-2) - U20-2 (BD-2) Always Below 1 Ω
U19-2 (BD+2) or U20-1 (BD+2) - Body ground Always 10 kΩ or higher
U19-1 (BD-2) or U20-2 (BD-2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.REPLACE POWER BACK DOOR UNIT ASSEMBLY SET RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.REPLACE POWER BACK DOOR UNIT ASSEMBLY SET RH
a.

Temporarily replace the power back door unit assembly set RH with a new or normally functioning one.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR DRIVE UNIT>REMOVAL


Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Back Door > Clear DTCs
50002 159

b.

Check for DTCs.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Back Door > Trouble Codes
50001 159

Result:
Proceed to
DTC B2229 is not output
DTC B2229 is output



DTC B2229 is not output

END (POWER BACK DOOR UNIT ASSEMBLY SET RH WAS DEFECTIVE)

DTC B2229 is output

REPLACE MULTIPLEX NETWORK DOOR ECU