Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR TOUCH SENSOR
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0061408 POWER BACK DOOR TOUCH SENSOR A

DOOR / HATCH  POWER BACK DOOR TOUCH SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS


PROCEDURE

Hide 1.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH

a.
B341618
1.969,1.573 2.198,1.781 0.229,0.208 10 (1) 2.917,1.156 3.135,1.365 0.219,0.208 10 (2) 2.323,1.365 2.521,1.563 0.198,0.198 10 (3) 1.656,2.542 1.854,2.75 0.198,0.208 10 (4)

Attach the 3 clips to the power back door sensor assembly LH.


b.

Install the power back door sensor assembly LH with the 4 screws.

Torque:
3.5 N*m (36 kgf*cm, 31 in.*lbf)

HINT:

Tighten the screws in the order shown in the illustration.



c.

Connect the connector.


Hide 2.INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 3.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 4.INSTALL BACK DOOR SIDE GARNISH LH

Hide 5.INSTALL BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 6.INSTALL BACK DOOR CENTER GARNISH