Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER ECU
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0061409 BACK DOOR CLOSER ECU A

DOOR / HATCH  BACK DOOR CLOSER ECU  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS


NOTICE:

When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) is memorized, so be sure to make a note of the automatic open stop position.


PROCEDURE

Hide 1.INSTALL MULTIPLEX NETWORK DOOR ECU

a.
B336830
2.5,1.292 2.958,1.49 0.458,0.198 10 (1) 0.625,1.313 1.083,1.51 0.458,0.198 10 (2)

Temporarily install the multiplex network door ECU by attaching the guide and clamp of the multiplex network door ECU to the door panel.


b.

Install the multiplex network door ECU with the 2 bolts.

HINT:

Tighten the 2 bolts in the order shown in the illustration.


Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


c.

Connect the 2 connectors.


Hide 2.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 3.INSTALL BACK DOOR SIDE GARNISH LH

Hide 4.INSTALL BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 5.INSTALL BACK DOOR CENTER GARNISH

Hide 6.SET MULTIPLEX NETWORK DOOR ECU

HINT:

When replacing the multiplex network door ECU, be sure to set it to the back door memorized automatic open stop position (memory stopped position) before performing the replacement.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>OPERATION CHECK