The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.
Replace the No. 3 ultrasonic sensor (rear corner sensor RH) with a normally functioning sensor.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
Check the operation of the Intuitive parking assist-sensor system.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTUITIVE PARKING ASSIST SYSTEM>OPERATION CHECK
| Proceed to |
|---|
| Intuitive parking assist-sensor system normal operation |
| Intuitive parking assist-sensor system malfunction |
Intuitive parking assist-sensor system normal operation
Intuitive parking assist-sensor system malfunction
Disconnect the S1 No. 3 ultrasonic sensor (rear corner sensor RH) connector.
Disconnect the S2 No. 3 ultrasonic sensor (rear center sensor RH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S1-3 (SI) - S2-4 (SO) | Always | Below 1 Ω |
| S1-1 (BI) - S2-2 (BO) | Always | Below 1 Ω |
| S1-5 (EI) - S2-6 (EO) | Always | Below 1 Ω |
| S1-3 (SI) - Body ground | Always | 10 kΩ or higher |
| S1-1 (BI) - Body ground | Always | 10 kΩ or higher |
| S1-5 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG