Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY › from 2013.11
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051200 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR DIFFERENTIAL SUPPORT

a.
C127579

Install the rear differential support to the differential carrier sub-assembly with a new 4 bolts.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)


Hide 2.INSTALL REAR NO. 1 AND NO. 2 DIFFERENTIAL SUPPORT

a.
C283458

Install the rear No. 1 and No. 2 differential supports with a new 4 bolts to the differential carrier sub-assembly.

Torque:
55 N*m (561 kgf*cm, 41 ft.*lbf)


Hide 4.INSTALL REAR DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 5.INSTALL REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY

a.

Support the rear differential carrier sub-assembly with a transmission jack or equivalent.


b.
C283459
0.271,0.354 0.427,0.552 0.156,0.198 10 false A 1.063,3.438 1.219,3.635 0.156,0.198 10 false A 2.917,3.448 3.073,3.646 0.156,0.198 10 false B

Slowly raise the transmission jack, and install the 3 bolts.

Torque:
for bolt A : 88.8 N*m (906 kgf*cm, 65 ft.*lbf)
for bolt B : 106 N*m (1080 kgf*cm, 78 ft.*lbf)

NOTICE:
·

Tighten the bolts, not the nuts.

·

Install a new bolt (labeled B).




c.

Install the breather tube.


d.

Install the wire harness clamp bracket with the bolt.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)


e.

Connect the connector.


f.

Connect the 2 harness clamps.


Hide 6.INSTALL REAR SUSPENSION MEMBER BRACE LH

a.

Install the member brace with the 2 bolts to the suspension member.

Torque:
32 N*m (326 kgf*cm, 24 ft.*lbf)


Hide 7.INSTALL REAR SUSPENSION MEMBER BRACE RH

HINT:

Use the same procedure described for the LH side.


Hide 8.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 10.INSTALL FUEL TANK ASSEMBLY