Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0054849 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  CD cannot be Inserted / Played or CD is Ejected Right After Insertion  


PROCEDURE

1.CHECK IF A PROPER CD IS INSERTED
a.

Make sure that the CD is an audio disc or a disc with MP3, WMA or ACC files, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

HINT:
·

Translucent or uniquely-shaped CDs cannot be played.

·

CDs with adhesive paper labels should not be played.

·

Commercial audio CDs can be played.

·

CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.

·

MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.

·

For details on playable CDs, refer to the Owner's Manual.



OK:

CD is normal.



Result:
Proceed to
OK
NG



OK

2.CHECK THAT CD IS INSERTED PROPERLY

NG

END (CD IS DEFECTIVE)

2.CHECK THAT CD IS INSERTED PROPERLY
a.

Check whether or not the CD is inserted upside down.

OK:

CD is properly inserted.



Result:
Proceed to
OK
NG



OK

3.CLEAN CD AND RECHECK

NG

SET CD PROPERLY

3.CLEAN CD AND RECHECK
a.
I100151

Disc cleaning

i.

If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

NOTICE:

Do not use a conventional record cleaner or antistatic preservative.


OK:

Malfunction disappears.




Result:
Proceed to
OK
NG



OK

END (CD IS DIRTY)

NG

4.CHECK CD
4.CHECK CD
a.

Replace the CD with a known good one and check that the malfunction disappears.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END (CD IS DEFECTIVE)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY