Home › Audio / Visual / Telematics › AUDIO / VIDEO › SATELLITE RADIO TUNER › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0102759 SATELLITE RADIO TUNER A

AUDIO / VIDEO  SATELLITE RADIO TUNER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type, w/ Satellite Radio)

Hide 4.REMOVE WIRE HARNESS

E288771

a.

Disconnect each connector and remove the wire harness.


Hide 5.REMOVE NO. 1 RADIO BRACKET

E288775

a.

Remove the 5 screws and No. 1 radio bracket.


Hide 6.REMOVE NO. 2 RADIO BRACKET

E288776

a.

Remove the 5 screws and No. 2 radio bracket.


Hide 7.REMOVE STEREO COMPONENT TUNER ASSEMBLY

a.
E288777

Detach the 2 guides and remove the stereo component tuner assembly as shown in the illustration.