1.INSTALL STEREO COMPONENT TUNER ASSEMBLY
Attach the 2 guides to install the stereo component tuner assembly as shown in the illustration.
2.INSTALL NO. 1 RADIO BRACKET
Install the No. 1 radio bracket with the 5 screws.
3.INSTALL NO. 2 RADIO BRACKET
Install the No. 2 radio bracket with the 5 screws.
4.INSTALL WIRE HARNESS
Connect each connector to install the wire harness.
5.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type, w/ Satellite Radio)
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION